Universal Fuel Pump Hardwire Kit

Now being offered for a Universal Application!

Its no secret that the fuel pump wiring is notoriously undersized, most stock wiring is ok for stock pumps but tend to see a voltage drop from the battery (sometimes an entire 2v loss) and simply not enough to run aftermarket pumps at their full potential.

Supporting rear battery locations as Single and Dual pump configuration, this kit will give you 30Amps of power to drive whatever you can toss at it.  Power is provided via a Deutsch DTP connector and the signal to tie in to the existing chassis wiring or customer chassis wiring will be through a Deutsch DTM connector.  Mating connectors are provided to complete the install.

Triggering of the hardwire kit can be accomplished via Low side (ECU trigger to Black and White to switched +12v) or High side (White to Switched +12v and black to ground).  For Dual pumps, there will be a trigger wire for each.  Wire these individually for Independent activation or combine them for Tandem operation.  

If you have any questions, please don't hesitate to reach out for assistance.